![]() My Network has DHCP on it, so my router picked up an IP from my LAN, and once I’d given it a default route, I now have full internet access from the lab. You may want to change the name from Net, to something like ‘Internet’.Ĭonnect a device to it, (I’m using a router, because they are quick and easy to setup). Select Cloud1 (remember this is mapped to pnet1, which is bridged to eth1.). In your lab workspace add a ‘Network’ object. I think these kind of problems mostly have to do with your image or the templates and software versions that Eve-NG supports. Now they are labelled Cloud1, Cloud2, etc. These used to be labelled pnet1, pnet2, etc. On the Security tab > Tick ‘Override’, and set it to ‘Accept’ > OK.įorged Transmits: You will also need to enable this, (if you use VLAN tagging in your network!)Ībove, (if you remember) the vNIC (eth1) was bridged to pnet1. EVE-ng Images + Super Study Material Pack - 59.99/year Eve-ng Images1. If you are using the older VMware (Fat) client, see the link at the bottom of the page for the older UNL article. For any Queries you can comment below or write us on. so we need to enable promiscuous mode on the port-groupthat we connected to earlier, (mine was called VM Network). Your Hyper Visor (VMware) needs to be able to see traffic from your EVE-NG devices, coming out though the vNIC we added earlier, that means a lot of MAC addresses are going to be coming from the MAC address of that vNIC. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |